Table of Contents
Advertisement
2.3.1 DACT-E3 Installation Configurations
2.3.1.1 DACT-E3 Installation in an E3 Series, Cabinet Configuration
In an E3 Series cabinet configuration, the PCB orientation of the DACT-E3 sub-assembly is usually installed above the ILI-MB-E3
or ILI95-MB-E3 sub-assembly as part of a backbox or a mounting plate configuration. To install the DACT-E3, refer to the
following instructions.
1.
Insert and secure eight standoffs (3/16" HEX #4-40, x 1.25") in the ILI-MB-E3/ILI95-MB-E3 as shown in Location 1 of
Figure 2.3.1.1.1.
2.
Align and place the DACT-E3 on the left side and above the ILI-MB-E3/ILI95-MB-E3.
3.
Insert and secure four screws (#4-40 x 1/4") into the four standoffs as shown in Location 2 of Figure 2.3.1.1.1.
NOTE: BACKBOX INSTALLATION:
If the DACT-E3 is installed to the backbox, use four screws (#4-40 x 3/8") and secure the screws into the four studs on the
backbox.
Figure 2.3.1.1.1 illustrates the DACT-E3 installed to the Cabinet C, E3-INCC-CAB-C plate.
Figure 2.3.1.1.1 DACT-E3 Circuit Board Installed to a Mounting Plate
4
CABINET C,
E3-INCC-C PLATE
2
SCREW,
2
#4-40 x ¼"
8 PLACES
DACT-E3 Product Installation Document — P/N 9000-0581:J6 12/16/2019
1
1
1
1
1
1
1
STANDOFF,
3/16" HEX
#4-40 x 1.25"
8 PLACES
1
Advertisement
Table of Contents
