Table of Contents
Advertisement
9. CONFIRMATION OF FIRMWARE VERSION
The Firmware version can be confirmed by ordering the following steps:.
- Step 1. The temporary cancellation of factory setting:
Set the mode dial to " [Normal Picture] (Red camera mark)".
While keep pressing [Optical Image Stabilizer] and " [UP] of
Cross key" simultaneously. turn the power on with inserting the
SD memory card which has a few photo data.
- Step 2. Confirm the version:
Set the mode dial to " [Playback] " and then press [DISPLAY] to
switch to LCD with indication. (Fig. A)
Press [Optical Image Stabilizer] and " [DOWN] of Cross key"
simultaneously. (No need to keep pressing.)
(The version information is displayed on the LCD with green
colour letters.) (Fig. B)
CAUTION:
The version information does not display if the LCD has switched
to LCD with indication already.
In this case, press [DISPLAY] to switch to LCD with indication.
Point:
- The firmware version and EEPROM version can be confirmed with
the information (1).
- The information (2), (3) are just reference.
PDF created with pdfFactory Pro trial version
24
www.pdffactory.com
Advertisement
Table of Contents
