Confirmation Of Firmware Version; Disassembly Procedure; Disassembly Flow Chart - Panasonic Lumix DMC-FZ10PP Service Manual

- 5. How to returned to Normal Display:
Turn the power off and on, to exit from Error code display
mode.
NOTE:
The error code can not be initialized by the unit only.

11. CONFIRMATION OF FIRMWARE VERSION

The Firmware version can be confirmed by ordering the following steps:.
- Step 1. Turn the Power on:
Turn the Power on with inserting the SD memory card which has a
few photo data.
- Step 2. Confirm the version:
Set the mode dial to " [Playback] ".
Press [Burst] and " [DOWN] of Cross key" simultaneously. (No
need to keep pressing.)
(The version information is displayed on the LCD with red colour
letters.)
<Point>
- The firmware version and EEPROM version can be confirmed with
the information (1).
- The information (2)-(4) are just reference.
<NOTE>
The Sub-uCOM version (stored in IC7201: Masked type) is not rewrite-able. / Necessary data of
IC7202 (EEPROM) is updated automatically, when the stored data in IC6004 (Flash ROM) is
changed.

12. DISASSEMBLY PROCEDURE

12.1. DISASSEMBLY FLOW CHART

19