Configuring The Hourly Time Signal Setting; Turning Off An Alarm Or The Hourly Time Signal; Tide Level And Moon Age; Checking The Current Tide Level - Casio 3522 Operation Manual

Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
[SIG] (hourly time signal) is shown on
●
the display while the hourly time signal
is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Snooze Hourly time signal
Alarm
Watch Operation Guide 3522
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through alarms ([1], [2],
[SNZ]) until the one you want to configure
is displayed.
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
Each press of (A) toggles between on
●
and off.
Turning off all alarms will cause [ALM]
●
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
If [ALM] (alarm) is still displayed, it
●
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Alarm or hourly time signal
Tide Level and Moon
Age
You can use the procedures in this section to
check the tide level and Moon age in your
currently selected Home Time city.
Important!
Displayed information is intended for
●
reference only. Do not use it for
maritime navigation, etc.
Before viewing a tide level or Moon
●
age, you need to configure settings
(UTC offset, longitude, lunitidal
interval) for the location where you are
using the watch.
Specifying Where You are Using
l
the Watch
Checking the Current Tide
Level
The Tide Graph for the current time is shown
in the Timekeeping Mode.
Tide Graph
Interpreting Tide Graph Information
High tide
Low tide
Falling tide Rising tide
10