Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
A
Start
(Countdown starts)
A
Pause
A
Resume
(Time up)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
To reset a paused countdown to the
●
start time, press (C).
3.
Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
The beeper will not sound if battery power
●
is low.
Operation Guide 5594
Configuring Alarm Settings
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (A) and (C) to display the number
([AL1] to [AL5]) of the alarm whose
settings you want to change.
Alarm number
Alarm time
3.
Hold down (D) for at least two seconds.
Release the button when the hour digits
start to flash.
The
(alarm) indicator is displayed
●
when any alarm is turned on.
Hours
4.
Use (A) and (C) to change the hour setting.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (E).
This causes the minutes digits to flash.
6.
Use (A) and (C) to change the minute
setting.
7.
Press (D) to exit the setting screen.
8.
Hold down (E) for at least two seconds to
return to the Timekeeping Mode.
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
1.
2.
3.
Minutes
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
You can also use G-SHOCK
●
Connected to configure alarm time
settings.
Configuring the Hourly Time
Signal Setting
Enter the Alarm Mode.
Navigating Between Modes
l
Press (A) or (C) to display the hourly time
signal screen ([SIG]).
Press (D) to toggle the hourly time signal
between enabled (on) and disabled (off).
(hourly time signal) is shown on the
●
display while the hourly time signal is
enabled.
Note
You can also use G-SHOCK
●
Connected to configure the hourly time
signal setting.
29