Table of Contents
Advertisement
Spreads.qxd
11/9/07
12:19 PM
Settings
Your Detector
Alert Settings
Pop Alert
When Pop Detect mode is on, Pop radar signals will be detected and an alert
will be given. During the alert, the unit will continue to detect other signals.
The factory setting is Pop Detect off.
X Band Alert
When X Band Detect mode is on, X Band radar signals will be detected and
an alert will be given. During the alert, the unit will continue to detect other
signals. The factory setting is X Band Detect on.
K Band Alert
When K Band Detect mode is on, K Band radar signals will be detected and
an alert will be given. During the alert, the unit will continue to detect other
signals. The factory setting is K Band Detect on.
Ku Band Alert
When Ku Band Detect mode is on, Ku Band radar signals will be detected and
an alert will be given. During the alert, the unit will continue to detect other
signals. The factory setting is Ku Band Detect off.
VG-2 Alert
The detector is undetectable by VG-2 detection devices and can alert you when
such a device is in use near your vehicle. When VG-2 Detect mode is on, VG-2
signals will be detected and an alert will be given. During the alert, the unit will
continue to detect other signals. The factory setting is VG-2 Detect off.
VG-2 Audio Mode
When VG-2 Audio mode is on, alerts will be sounded as well as being
displayed on the screen. This setting is only available if VG-2 Alert is on.
The factory setting is VG-2 Audio off.
Spectre 1 Alert
The detector is undetectable by Spectre 1 detection devices and can alert you
when such a device is in use near your vehicle. When Spectre 1 Detect mode
is on, Spectre 1 signals will be detected and an alert will be given. During the
alert, the unit will continue to detect other signals. The factory setting is
Spectre 1 Detect off.
20 English
Page 17
Settings
Your Detector
Set Compass
•
After the detector is installed in your vehicle and Compass is turned on
(see page 34), the system will automatically advance to the Set Compass
calibration screen from which the calibration can be performed.
WARNING
Before calibrating the Compass, go to a large parking lot
or other safe, low-traffic area.
NOTE
When the instructions direct you to drive in two circles, make two complete
loops (in either direction) from any starting orientation at any convenient speed.
The loops need not be perfect and can be circles, small squares, four three-
point turns, or any pattern that makes at least two complete turns within two
minutes of starting the maneuver
Calibrating the Compass progresses from the Calibrate Compass screen shown
on the User Programming Menu Guide (see page 34). From that screen:
1. Press the Mute
2. Drive your vehicle in two circles.
3. Press the Mute
The system will store the calibration data and provide a completion message
on the display as well as a tone or voice message.
NOTE
If you do not press the Mute
Set Compass process, Compass calibration will automatically terminate. The
unit will provide a corresponding message.
Once the initial calibration is complete, you can go to Set Compass in
User Settings Programming and recalibrate the Compass as needed by
repeating the three-step calibration process.
.
button to advance to the Compass screen.
button to complete the setting process.
button within two minutes after beginning the
Nothing Comes Close to a Cobra
®
17
Advertisement
Table of Contents
