Linksys EG1032 User Manual page 15

11. NT will copy the necessary network
drivers to your PC. When the copying
is complete, you will see a list of
installed bindings. Change the bind-
ings settings if needed and click Next.
Click Next again.
12. Choose either Workgroup or Domain, depending on the type of network
you're setting up. (Your Microsoft documentation explains the difference
between Workgroups and Domains.) Click Next.
23
Instant Gigabit Series
N N o o t t e e : : For information and
help on choosing your bind-
ings, services and protocols,
ask your network administra-
tor, or check your Windows
NT documentation.
Instant Gigabit Network Adapter (EG1032/EG1064)
13. Click Finish. When asked if you want to restart your computer, remove the
Driver Disk and click Yes.
14. Once your PC has rebooted and you are logged in, double-click the
Network Neighborhood icon on your desktop. Ensure that you have
access to the network. If you do, your card has been properly installed.
• If you had previously installed a NT service pack, you must re-install that
now.
• If you need to install the TCP/IP protocol, refer to your system administra-
tor or your Windows NT documentation. Linksys does not provide techni-
cal support for the configuration or troubleshooting of the TCP/IP proto-
col
The Windows NT Installation and Setup of the Instant Gigabit Network
Adapter is complete. Do not continue on with the next set of instructions.
They are for NT users who already have their networking configured.
N N o o t t e e : : For information and help on choosing your bind-
ings, services and protocols, ask your network admin-
istrator, or check your Windows NT documentation.
N N o o t t e e : If you had previously installed an NT service pack,
you must reinstall it now.Otherwise, you may receive Not
Enough Service Storage Space errors in the Event
Viewer.
24