Linksys WRV200 User Manual page 61

Wireless-G VPN Router with RangeBooster
SNMP
SNMP, Simple Network Management Protocol, is a network protocol that provides network administrators with
the ability to monitor the status of the Router and receive notification of any critical events as they occur on the
network.
To enable SNMP, check the Enabled box. To configure SNMP, complete all fields on this screen. To disable the
SNMP agent, remove the checkmark.
Identification
Contact. Enter the name of the network administrator for the Router, as well as a contact number or e-mail
address.
Device Name. Enter the name of the Router.
Location. Enter the location of the Router. For example, you could include the name of the building, floor number,
and room location, such as Head Office - Floor 5 - Networking 3.
Get Community. Enter the password that allows read-only access to the Router's SNMP information. The default
name is public.
Set Community. Enter the password that allows read/write access to the Router's SNMP information.The default
name is private. A name must be entered in this field.
SNMP Trap-Community. Enter the password required by the remote host computer that will receive trap
messages or notices sent by the Router.
SNMP Trusted Host. You can restrict access to the Router's SNMP information by IP address. Enter the IP
address in the SNMP Trusted Host field. If this field is left blank, then access is permitted from any IP address.
SNMP Trap-Destination. Enter the IP address of the remote host computer that will receive the trap messages.
UPnP
Universal Plug and Play (UPnP) allows Windows XP, Windows 2000, and Windows Me to automatically configure
the Router for various Internet applications, such as gaming and videoconferencing. To enable UPnP, check the
Enabled box.
Chapter 6: Configuring the Wireless-G VPN Router 51
The Administration Tab - Management