Linksys PC22224 User Manual page 55

6. To change the average rate setting, press the Enter key. The Average Rate
screen appears.
7. Highlight the desired rate and press the Enter key. The rate you selected
appears next to Average Rate.
8. To change the traffic type, press the Down Arrow key to highlight Traffic
Type, then press the Enter key. The Traffic Type screen appears.
102
ProConnect II
® Series
2224 Layer 2 Management 24-Port 10/100 Ethernet Switch
9. Highlight either Bursting or Streaming, then press the Enter key. Your
selection appears next to Traffic Type.
10. Press the Esc key until you return to the desired screen.
Sending and Receiving Files
If you select File Transfer from the Advanced Management screen, the fol-
lowing File Transfer screen appears, with the Receive File via TFTP value
highlighted. You can use this screen to send and receive files using the TFTP
or Kermit protocol.
Receiving Files via TFTP
The following procedure describes how to receive files using the TFTP protocol.
Note
The TFTP protocol is used to download upgraded software to the switch. A
VLAN with the proper IP address and routing path to the TFTP server must be
configured for the switch to access the specified TFTP server.
1. Press the Enter key. The Receive File Via TFTP screen appears.
n nect II 2224
103