Assembling The Chain Brake - Husqvarna 543 XP Workshop Manual

Safety equipment

6.2 Assembling the chain brake

1
Fit the knee joint and the brake band together (see
figure 5). Place the knee joint with the fitted chain
brake band in the opening in the clutch cover. The
space for the spring in the cover must be lubricated
with grease, see figure 5.
2
Compress the spring with a wide screwdriver (or
special tool 513 63 70-01) and press it down with
your thumb, see figure 6.
WARNING!
Exercise care to ensure the spring
does not fly out and cause personal
injury. Wear protective goggles.
3
Fit the two covers using 0,7-1,5 Nm tightening
torque, see figure 7.
4
Tension the spring by pressing down on the lever.
See figure 8.
5
Fit the guide bar, saw chain and clutch cover.
See figure 9.
18
- English
Fig 5
Fig 6
Fig 7
Fig 8
Fig 9