Testing; Reconnect Battery; Test Power Wiring; Test Antenna Connection - Jensen CD511K How To Install

®

Testing

Before you finish the installation, you should do the following tests to make sure the wiring is correct
and everything is operating properly.

Reconnect Battery

When wiring is complete,
reconnect the battery
negative terminal.

Test Power Wiring

1. Press PWR button to turn the receiver on.
You will see the radio display. If not, check
electrical connections to the red and
yellow wires.
2. If equipped, the power antenna should
also operate. If not, check electrical
connections to the dark blue wire.

Test Antenna Connection

1
TUNE
TRACK
2
SEL
6
5598 CD511K_Ein.p65
1. Press the TUNE /
TRACK button
or . The radio
should tune to a
nearby station. If
not, check antenna
connection.
2. Turn the volume
knob to increase
volume until you
can hear the radio
playing.
6

Test Memory Wiring

1. With the radio playing,
1
1
D
DN
hold button 1 for two
seconds. You just stored
the current station in
memory.
2 Sec
2. Turn the key off, then
turn the key on again.
2
3. Press the TUNE /
TRACK button
a different station.
4. Press button 1 again. It
3
should return to the
station that was playing
before (step 1). If not,
TUNE
make sure the yellow
TRACK
wire is connected
properly.
4
1
D
DN
3/23/00, 2:05 PM
CD511K
or
. The radio will select