Remove Old Radio - Jensen CD511K How To Install

CD511K

Remove Old Radio

Your original car radio is installed in one of four ways, depending on the car.
Standard Bracket Mount
(GM, Dodge, Jeep)
1. Remove dashboard faceplate
2. Unscrew brackets
3. Disconnect wiring harness and remove radio
Replacing an Aftermarket Radio
Use a screwdriver to bend tabs completely out
of the way. Pull sleeve from dashboard. The
sleeve should fit tightly and may be damaged
unless you remove it carefully.
Bend
1
Tabs
Flat
5598 CD511K_Ein.p65
2 Pull Sleeve Out
Caution: Edges are
sharp. Use a rag
or wear a glove.
3
Front Load Mount
Some cars use a special removal tool
to release the radio (Ford and Mercury).
1. Insert the tool(s)
2. Pull out the radio
3. Disconnect wiring harness and
remove radio
Import Type Mount/With Factory Radio
1. Remove trim to expose DIN chassis.
2. Remove screws that secure radio to the
dashboard.
3. Remove brackets from the side of radio.
4. Disconnect wiring harness and remove
radio.
1
3/23/00, 2:05 PM
®
2
3
3