Processor - HP HPE ProLiant ML350e Gen8 Maintenance And Service Manual

Finish the installation by completely tightening the screws in the same sequence.
c.
Install the system air baffle.
4.
If removed, install the PCI air baffle.
5.
Install the access panel.
6.
Return the server to an upright position.
7.
Lock the front bezel.
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Power up the server (on page 25).
11.

Processor

CAUTION: To avoid damage to the processor:
• Handle the processor only by the edges.
• Do not touch the bottom of the processor, especially the contact area.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To remove the component:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the front bezel (on page 25).
3.
Place the server on its side.
4.
Remove the access panel
5.
If installed, remove the PCI air baffle
6.
Remove the system air baffle
7.
Remove the heatsink ("Heatsink" on page 43).
8.
("Access panel" on page 26).
("PCI air baffle" on page 27).
("System air baffle" on page 28).
Removal and replacement procedures 45