General; Gas Installation - Electrolux TD6-14 Installation Manual

9.2 General

May only be carried out by qualified personnel.
Mount a shut-off valve upstream from the machine.
The factory nozzle pressure setting corresponds to the fuel value given on the data label.
Check that the nozzle pressure and fuel value correspond with the values in the gas tables on the following pages. If
not, contact the supplier.
Bleed the pipe system before connecting the machine.
Note!
After connection all joints must be checked. There must not be any leaks.

9.3 Gas installation

This gas appliance is build to run on natural gas (group I2H and I2E), commonly identified by GNH.
Japan to run on LPG (group I3B/P) 2800 Pa inlet pressure, no regulation.
This default gas appliance is built to be installed at not over than 610 m (2001 ft) high altitude otherwise a kit for high
altitude must be installed to the machine. For the kit No. please refer to the spare parts list.
The data label shows the injector size and the injector pressure and the countries that use this gas quality:
AL Albania
AT Austria
BE Belgium
BG Bulgaria
CH Switzerland
CY Cyprus
CZ Czech Republic
DE Germany
DK Denmark
EE Estonia
ES Spain
FI Finland
FR France
GB United Kingdom
GR Greece
HR Croatia
HU Hungary
IE Ireland
You should check the kind of energy gas that is available in your place and check high altitude of the machine located
place.
There are many gas types of the same kind but the machine should be equipped with different kinds of nozzles de-
pending on the gas type.
For non-european countries check the heat value of the energy gas and compare it to the declared heat value of gas
in the attached label.
Installation manual
IS Iceland
IT Italy
JP Japan
LT Lithuania
LU Luxembourg
LV Latvia
MK Republic of Macedonia
MT Malta
NL Netherlands
NEC Non-european countries
NO Norway
PL Poland
PT Portugal
RO Romania
SE Sweden
SI Slovenia
SK Slovakia
TR Turkey
45