General Іга Айога - Electrolux EWED65HSS Installation Instructions Manual

Installation Instructions
17
General installation
Connect tne exhaust duct to the outside
exhaust system (see pages 5 through 7). Use
of a 4" (10.2 cm) clamp Is recommended to
connect tna dryer to the exhaust vent system.
Lise metal Toll tapa to seal all other joints.
Carefully slide tna dryer to Its final position.
Adjust ona or more of the lags until tna dryer Is
resting solidly en all Tour legs. Place a level on
top of the dryer. The dryer MUST be level and
resting sollaliy on all Tour lags. Rock altemating
corners to check for stability. Remove and
discard door tape.
=] IMPORTANT
Ba sura the power Is off at a circuit breakar/Tusa
box before plugging the power cord Into an outlet.
a.
4.
5.
Plug the power cord Into a grounded outlet.
Turn on the power at the dult breakenTuse
рох,
Read the Use & Care Guide provided with
the dryer. It contains valuable and helptul
Information that will save you time and money.
вав the newt page about performing a bref,
halprul "installation Cycle" Tor your new dryer.
Ії you have any questions during Initial
operation, please review the "Avold Service
Checkist In your Use & Care Guide betore
calling Tar service.
Place these Instructions In a location near the
dryer Tor future reference.
= NOTE
A wiring diagram and technical data sheet are
located Inside the dryer console.
Power cord with
3-prong grounded plug