Table of Contents
Advertisement
After you have made all necessary settings on the Remote Control Module, you can install it into the TOPAZ 12 pack.
Push the module in firmly making sure that the edge connectors are making full contact.
Control wiring to this module is via the 5-pin XLR connectors on the back of the pack. See Figure 6. If LEVITON control
cables are not available, cables must be made using Neutrik NC5MX-B (male) and NC5FX-B (female), or equivalent
connectors, and Belden 9829 or equivalent cable. Connector wiring is per the USITT DMX512 standard.
Plug the control console into the male connector marked "IN" for the first pack. Plug the male connector of a jumper cable
into the pack connector marked "OUT" and the other end of the cable into the next pack. Packs can be connected in any
order without regard to the thumbwheel switch-selected numbers. The complete installation must adhere to the EIA 422A
standard which, in general, limits the total cable length from console to last pack to 1000' (304.8m) and the number of
control modules to 16.
Now go on to the final assembly section of this manual, Chapter V.
TABLE 4
Control Connector Wiring
Pin No.
Function
1
Common
2
Data –
3
Data +
4
Not Used
5
Not Used
Page 9
Wiring
Shield
Pair 1
Pair 1
Pair 2
Pair 2
Control Out – To next pack
Control In – From console or another pack
Figure 6 - Control Connectors
Hide quick links:
Advertisement
Table of Contents
