Maintenance And Specifications - Leviton Topaz 24 Installation & Maintenance Manual

MAINTENANCE
Caution: Do not perform maintenance with the rack energized.
Every six months (or more often, if the environment is particularly dusty) clean any accumulation of dust from the fan grills, dimmer module air intake
openings, control module front and any other place dust may have accumulated. This may be done with compressed air or a vacuum. Also check all
electrical terminations for tightness, bus to bus, bus to lug, and lug or terminal to wire. Refer to Tables I & II for torque ratings on wire termination.
Rack Capacity:
Dimensions:
Weight:
Conduit Knockouts
Top and Bottom Load/Line:
Sides
Maximum Fan Noise Rating:
Ambient Operating Temperature:
Maximum Operating Humidity:
Maximum Feeder Size:
Nominal Input:
Phase-to-Neutral Operating Voltage:
Operating Frequency:
Rack Enclosure:
For further information on the operation of the TOPAZ 24 Rack refer to the user guides and operations manuals of the control console
or architectural control stations that will be used in conjunction with this product. For additional assistance, please contact the NSI
Technical Support Line, Monday through Friday, 8:00 am to 5:00 pm PST. 1-800-864-2502
Table IV - Specifications (per single rack section)
24 Circuits, 20 Amp max. per circuit.
21-5/8" H x 14" W x 9' D
(546mm H x 356mm W x 229mm D)
Empty - 30 lbs. (1 3.6 Kg.)
Full - 66 lbs. (29.9 Kg.)
4 concentric ½", ¾", l", 1 1¼" T.S.
1 concentric 1½", 2", 2½" T.S.
1 concentric ½", ¾" T.S.
Control Signal:
Bussing:
5 rectangular 2¼" x 2¾"
33dba, 20 Amp max. per circuit.
O˚C (32˚F) to 40˚C (104˚F)
90% without condensation.
200 Amp.
120/208V, 3Ø, 4W, 60 Hz, or (with LEC 2012 Kit Installed)
120 V Circuits:
120/240V, 1Ø, 3W, 60 Hz.
240 Circuits:
240/415V, 3Ø, 4W, 50/6OHz, or (with LEC 2012 Kit Installed)
240/480V, 1Ø, 3W, 50/6OHz
(FOREIGN ELECTRICAL
SERVICE ONLY)
120V± I 0% or 220/240V ± 1 0%
60 ± .5Hz or 50 ± .5Hzl
NEMA Type 1 for indoor use only (utilizer dans un endroit a I'abri)
Page 11