Set Thumbwheel Switch(Es); Set Non-Dim Switches - Leviton Topaz 24 Installation & Maintenance Manual

Step 12 - Set thumbwheel switch(es)
• Set the thumbwheel switch(es) on all TOPAZ 24 control modules according to Table III on next page. See Figure 6 (Pack 1 is usually the left-most pack).
Table III - Thumbwheel Switch Settings
PACK NUMBER
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Step 13 - Set Non-Dim switches
Note: if control module is not a Topaz Universal type, skip to the next step (Step 14).
• Switch Non-Dim switches to select which dimmers are to operate in the Non-Dim mode. The Non-Dim mode switches are located on the left-hand side of the top
printed-circuit board on the Universal Control Module. See Figure 7, page 7. In the off (left) position, the channel will function as a dimmer. In the on (right) position,
the dimmer will function as a non-dim (fully off or fully on).
CAUTION: Do not operate these switches while the pack is energized.
THUMBWHEEL SWITCH NUMBER
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Page 8