Table of Contents
Advertisement
2. Click Add New FRU.
3. Type the FRU's location code and its part number in the appropriate fields.
4. Click Add to List. The Update FRU Information window opens and displays the newly added FRU in
the lower table.
5. Click OK or Apply to commit these changes to the serviceable event.
Note: After you click OK or Apply, you cannot change this information. If you clicked the Close Event
button in the Serviceable Event Details window, then clicking OK also completes the close
dialog and changes the status of the serviceable event to Closed.
Viewing Serviceable Event Partition Information
You can view partition information associated with this serviceable event. This information includes each
affected partition's state and resource use.
1. Perform the steps in "Viewing Serviceable Event Details" on page 70.
2. Click Partition Information.
Activating and Deactivating FRU LEDs
This task allows you to activate or deactivate a managed system's system attention LED or any FRU LED.
FRU LEDs are helpful in determining which FRUs need servicing.
To activate or deactivate a managed system's system attention LED, do the following:
1. In the Navigation area, click the Service Applications icon.
2. In the Navigation area, double-click the Service Focal Point icon.
3. In the Contents area, select Hardware Service Functions. The LED Management window opens.
4. In the LED Management window, select one or more managed systems from the table.
5. Select either Activate LED or Deactivate LED. The associated System Attention LED is then either
turned on or off.
To activate or deactivate a FRU associated with a particular managed system, do the following:
1. In the Navigation area, click the Service Applications icon.
2. In the Navigation area, double-click the Service Focal Point icon.
3. In the Contents area, click Hardware Service Functions. The LED Management window opens.
4.
In the LED Management window, select one managed system from the table.
5. Click the List FRUs... button. The list of FRU slot indexes and their respective current LED states
display.
6. Select one or more FRU slot indexes.
7. Click either the Activate LED or the Deactivate LED button.
The associated FRU LEDs are now either enabled (blinking) or off.
Accessing System Log Error Information
Note: The system attention LED can be reset by following the procedures described in "Resetting the
System Attention LED" on page 73.
When an error is detected by the system, information about the error is stored in error logs. The following
sections explain how to access the logs that are available on a system. The error logs are accessed from
the console that is used to manage the system. From the following console descriptions, go to the
instructions under the heading that best describes the system on which you are working:
v "Accessing Errors when a System is Attached to an HMC" on page 73.
v "Accessing Errors when a System is Running AIX and the Console is Not an HMC" on page 73.
72
EserverpSeries 650 Service Guide
Advertisement
Table of Contents
