Ibm Hardware Management Console For Pseries (Hmc) To The Hmc Connector - IBM eserver p Series Service Manual

IBM Hardware Management Console for pSeries (HMC) to the HMC
Connector
To connect your HMC to the pSeries 650, connect a serial cable into a serial port on the HMC. The port
can be either a serial port on the back of the HMC or a serial port on an 8-port or 128-port async adapter.
Connect the other end of the serial cable into the HMC1 connector located on the rear of the processor
subsystem. The following illustration shows the location of the serial ports on the back of the HMC and the
HMC connectors located on the processor subsystem.
1 HMC (HSC) Port 1,
Location: U0.1-P2/S5
2 HMC (HSC) Port 2,
Location: U0.1-P2/S6
3 HMC
Optional 8-Port or 128-Port Async Adapters
Up to two optional async adapters can be installed in the HMC. The adapters have breakout boxes that
allow connection to serial cables that connect to the managed system's HMC ports.
18 EserverpSeries 650 Service Guide