Service manual
Valve hatch replacement-fitting
After fitting the previous parts the following parts should be fitted as previously shown:
Valve wheel (Page 33)
39
97 If previously removed fit the valve
hatch seal onto the valve ensuring
it is adequetly seated. Fit the valve
hatch over the lugs on the valve.
98 Locate the legs of the spring into
the channels on the hatch and
valve. Using a screwdriver hold
the spring under tension whilst
sliding the axle into position.
99 Hold the axle in place to stop it
from turning whilst fitting the screw
and plastic washer.
Fit the two halves of the ball
assembly and four screws.