11.0 - Dip-Switch Settings; Ultrasonic Volumetric Protection; 12.1 - Connections And Positioning; 12.2 - Sensitivity Adjustment - Gemini 823 Installation And Use Manual

11.0 - DIP-SWITCH SETTINGS

Set dip-switches BEFORE connecting the alarm system.
!
If settings must be modified after installation, FIRST disconnect the alarm and then
SWITCH N. POSITION
1 ON
1 OFF
2 ON
2 OFF
3 ON
3 OFF
Arm/disarm via door lock motors only or via motors and turn
4 ON
4 OFF
12.0 -

ULTRASONIC VOLUMETRIC PROTECTION

12.1 - CONNECTIONS AND POSITIONING

Insert the WHITE connector in the "W" marked socket and the RED connector in the "R" marked
socket (see figure below).
Install the ultrasonic sensor cells, inside the cabin. in the top corners of the front window pillars, away
from the air vents and point them towards the center of the rear window

12.2 - SENSITIVITY ADJUSTMENT

T o check sensor sensitivity level proceed as follows
!
With the alarm system disarmed, roll down the front window approx. 20 cm.
!
Set the trimmer to an intermediate position (medium sensitivity).
!
Close all doors, bonnet and boot and arm the system.
!
During the arming delay, introduce an object in the cabin through the window and move it around;
the status LED will turn OFF to signal a presence.
!
If the sensitivity level is too high or too low, readjust the trimmer and repeat the above procedure
SENSITIVITY
ADJUSTMENT
PAGE 12 - INSTALLER MANUAL
reset the dip-switches.
FUNCTION
WHITE/LIGHT BLUE wire reads POSITIVE polarity
WHITE/LIGHT BLUE wire reads NEGATIVE polarity
----------
Standard operation mode
Negative arm/disarm input
Positive arm/disarm input
indicators (par. 7.0)
Arm/disarm via turn indicators only
.
:
ULTRASONIC
CELL
CONNECTIONS
To carry out the operation successfully, make sure the required electrical connections
!
(door/bonnet switches and ignition) are properly connected.
Storing memory is for 55 devices. Adding an extra device will automatically delete the
!
To enter in programming mode proceed as follows:
!
With the system disarmed, open the driver door and the bonnet and leave them open
The " ON-OFF " cycles must be carried out within 4 seconds otherwise the procedure
!
!
Cycle ignition key 4 times within 4 sec. ("
with the key in the " ON " position.
!
A Beep, a Bop and a flash of the turn indicators will confirm the system is in learn mode. The LED
will also power ON steady .
Do not close the bonnet otherwise all previously programmed devices will be deleted
!
The system is ready to receive the device codes:
!
Touch the override key to its receptacle
!
A Beep will sound and the status LED will turn OFF briefly to confirm the device has been learned
!
R epeat the above procedure to program other devices.
!
Turn ignition key OFF.
!
A Bop and a flash of the turn indicators will confirm the end of the procedure. The status LED will
also power OFF.
.

13.0 - PROGRAM NEW DEVICES

first device stored in the alarm memory.
is invalidated.
ON-OFF ON-OFF ON-OFF ON "-" "-"
as described in the next paragraph.
.
INSTALLER MANUAL - PAGE 13
.
"-" ") ending the cycle
.