Panasonic PAN1782 Product Specification page 2

PAN1782 Bluetooth Module
Overview
The PAN1782 is a Bluetooth 5.1 Low Energy (LE)
module based on the Nordic nRF52833 single chip
controller.
Features
•
Surface Mount Type: 15.6 mm × 8.7 mm × 2 mm
•
Pin compatible hardware drop-in replacement for
PAN1026A, PAN1762, and PAN1781
•
Nordic nRF52833 featuring ARM
running with 64 MHz
•
Bluetooth 5.1 LE including LE 2M and LE coded
PHY
•
Embedded 512 kB flash memory and 128 kB
internal RAM
•
128-bit AES/ECB/CCM/AAR co-processor
•
Up to 16 General Purpose I/O's (GPIO), which
are shared with up to 4× SPI, 2× I²C, 2× UART,
8CH ADC, COMP, QDEC, NFC-A, 4× PWM,
nRESET. Usage is limited by number of
available GPIO ports.
•
USB 2.0 full-speed device interface
•
Built-in temperature sensor
Block Diagram
Product Specification Rev. 1.0
Bluetooth
•
LE 2 Mbps high speed PHY, LE long range
coded PHY
•
LE advertising extensions (advertising on
40 channels total)
•
Channel selection algorithm #2
•
LE secure connections
•
Angle of arrival (AOA) and angle of
departure (AOD) direction finding
Characteristics
® ®
Cortex -M4
•
Typical sensitivity: -96 dBm at 1 Mb/s
and -103 dBm at 125 kb/s
•
Typical max. output power: 8 dBm, configurable
from -20 dBm in 4 dB steps and -40 dBm in
whisper mode
•
Typical current consumption: 4.9 mA in Tx
(at 0 dBm) and 4.7 mA in Rx mode
•
Typical current consumption: 0.6 µA in System
OFF mode, 1.5 µA with RTC wake up
•
On-module DC-DC and LDO regulators with
automated low current modes
•
Voltage range: 1.7 V to 5.5 V
•
Temperature range: -40 °C to 85 °C
Page 2 of 42