Adjusting The Projected Image - BenQ EH620 User Manual

Adjusting the projected image

Adjusting the projection angle
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes
trapezoidal. You can screw the adjuster feet to
fine-tune the horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
Fine-tuning the image size and clarity
Adjust the projected image to the size that you
need using the zoom ring.
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to angled
projection.
To correct this, make sure that the input source is NOT BenQ Launcher and Auto Vertical
Keystone is Off.
Press / on the remote control or
to display the Keystone correction page. Press
keystoning at the top of the image. Press
keystoning at the bottom of the image. When Keystone OSD
pops up, long press OK for 2 seconds to enable Auto
V-Keystone. When Keystone OSD pops up, long press
Sharpen the image by rotating the focus ring.
/ on the projector
to correct
to correct
(BACK) for 2 seconds to reset Keystone.
Press
/ .
Positioning your projector
/
Press
.
17