Table of Contents
Advertisement
Controlling the projector via LAN
Wired LAN allows you to manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the LAN input jack of the projector and the other end to
the RJ45 port.
• When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or
interruption.
2. Go to Advanced Menu - System > Network > Wired LAN. Press OK. The Wired LAN
page appears.
3. Press
to select DHCP and press
4. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page.
5. The IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be displayed.
Note down the IP address displayed in the IP Address row.
• If the IP Address still does not display, contact your ITS administrator.
6. Go back to Advanced Menu - System > Network > Wired LAN page.
7. Press
to highlight AMX Device Discovery and press
Device Discovery is On, the projector can be detected by AMX controller.
If you are in a non-DHCP environment:
1. Go to Advanced Menu - System > Network > Wired LAN page.
2. Press
to select DHCP and press
3. Contact your ITS administrator for information on the IP Address, Subnet Mask, Default
Gateway, and DNS Server settings.
4. Press
to select the item you want to modify and press OK.
5. Press
/
to move the cursor and then press
6. To save the setting, press OK. If you do not want to save the setting, press BACK.
7. Press
to highlight Apply and press OK.
8. Go back to Advanced Menu - System > Network > Wired LAN page., press
AMX Device Discovery and press
9. Press MENU to exit the menu.
/ to select On.
/
to select Off.
/ to enter the value.
/
to select On or Off.
/
to select On or Off. When AMX
Operation (under non-Launcher source)
to highlight
53
Advertisement
Table of Contents
