Table of Contents
Advertisement
Setting the Template Items
Memory
Use this page to edit the Memory channels data, Skip Memory channels, or PMS (Programmable Memory
Scan) memory channels.
• Memories
Enter and edit the frequencies you normally use to the memory channels. Up to 999 channels can be
registered.
• PMS
Edit the upper and lower limit frequencies for performing PMS (Programmable Memory Scan).
Enter the lower limit frequency for the L channel and the upper limit frequency for the corresponding U
channel. Up to 50 pairs (100 channels) of PMS can be registered.
About the setting items of each memory channels
• Receive Frequency/ Transmit Frequency
Enter the desired receive/transmit frequency. When the frequency entry is complete, use the → key to
move the cursor to the right and subsequently configure the additional detail settings for the channel. To
enter the transmit frequency for the next channel, press the ENTER or ↓ key. The receive and transmit
frequencies can be set separately.
• Offset Frequency
When a transmit frequency is not entered, transmission will be performed at a frequency obtained by add-
ing/subtracting the offset frequency to/from the receive frequency.
• Offset Direction
Set the frequency shift direction.
OFF:
The transmit frequency is not shifted.
-RPT:
The transmit frequency is shifted to the minus offset.
+RPT:
The transmit frequency is shifted to the plus offset.
-/+:
Transmit frequency/receive frequency enabled.
22
Advertisement
Table of Contents
