Appendix; Code Configurations - Siemens SIMATIC MV320 Operating Instructions Manual

Hide thumbs Also See for SIMATIC MV320:

Table of Contents

Appendix

A.1

Note

Changing the configuration

Changes to the configuration take effect immediately and are stored.

Note

Rate of data transmission depends on set keyboard

Note that the data transmission rate is slower with a set universal keyboard (Universal

Keyboard Mapping) than with selection of a specific keyboard language (e.g. US keyboard).

Codes for configuration of the device

A current list of the codes for configuration of the SIMATIC MV320 optical handheld reader is

available at the following link:

MV320 Configuration Guide (https://support.industry.siemens.com/cs/ww/en/ps/15160/man)

Motion detection with the optical handheld reader with and without stand detection

If the optical handheld reader is placed on a stand, the optical handheld reader reader with

stand detection automatically switches to the motion detection mode.

• When the code for "Disable Motion Detection with Stand Detection" is scanned in, the

optical handheld reader switches to the motion detection mode. Detection depends on

whether or not the optical handheld reader is on a stand.

• To disable motion detection, you need to scan in the code for "Disable Motion Detection

with Stand Detection" and "Motion Detection Scanning Off".

• To enable motion detection on optical handheld readers with stand detection after

disabling motion detection:

You need to scan in the code for "Enable Motion Detection with Stand Detection"

• To enable motion detection on optical handheld readers without stand detection:

You need to scan in the required code for "Motion Detection On".

SIMATIC MV320 (as of FS: A3)

Operating Instructions, 03/2021, C79000-G8976-C643-01

Table of Contents