Connection; Connecting And Removing Cables - Siemens SIMATIC MV320 Operating Instructions Manual

Connection

NOTICE
Avoid exceeding the maximum voltage
If the maximum voltage is exceeded, this voids the manufacturer's guarantee.
• Maximum voltage tolerance: 5 V ± 10 %
• The components must comply with the requirements of the EC directive RoHS and the
REACH Regulation: See EC directive 2011/65/EU (RoHS 2) and the Regulation (EC) No.
1907/2006 (REACH Regulation).
3.1

Connecting and removing cables

Connecting the cable
Proceed as follows to connect the cable to the device:
1. Plug the RJ-50 end of the cable into the bottom of the device.
2. Press the plug firmly into the device until it audibly locks in place.
Result: The cable is properly connected.
SIMATIC MV320 (as of FS: A3)
Operating Instructions, 03/2021, C79000-G8976-C643-01
3
13