Evb Vsi - HP S5830V2 Series Command Reference Manual

VDP resource-wait-delay exponent
26
27
28
29
30
31
Examples
# Configure the VDP resource-wait-delay exponent for Ten-GigabitEthernet 1/0/1 as 23.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] evb vdp timer resource-wait-delay exponent 23

evb vsi

Use evb vsi to create a VSI.
Use undo evb vsi to remove a VSI.
Syntax
evb vsi vsi-local-id { association | pre-association }
undo evb vsi vsi-local-id
Default
No VSI exists on an S-channel.
Views
S-channel interface view
Predefined user roles
network-admin
Parameters
vsi-local-id: Specifies a VSI local ID in the range of 0 to 1023.
association: Specifies the association property. On a VSI with the association property, all filters
immediately take effect.
pre-association: Specifies the pre-association property. On a VSI with the pre-association property,
VLAN filters take effect, but <VLAN, MAC> filters are not effective.
Usage guidelines
• A VSI is usually created or deleted by a VSI manager. You can also manually create or delete a VSI,
or modify its pre-association or association property by executing this command.
A VSI is a subinterface of an S-channel interface. Removing an S-channel also removes all its VSIs.
•
When you change association to pre-association for a VSI, if MAC address information is
•
contained in the traffic sent by a VM, the MAC address is removed from the drive on the EVB bridge,
Calculated value (seconds)
671.08864
1342.17728
2684.35456
5368.70912
10737.41824
21474.83648
16
Result value (seconds)
672
1343
2685
5369
10738
21475