Evb Vsi Filter; Interface S-Channel - HP S5830V2 Series Command Reference Manual

evb vsi filter

Use evb vsi filter to configure a VSI filter.
Use undo evb vsi filter to remove a VSI filter.
Syntax
evb vsi filter vlan vlan-id [ mac mac-address ]
undo evb vsi filter [ vlan vlan-id [ mac mac-address ] ]
Default
No VSI filter exists.
Views
VSI view
Predefined user roles
network-admin
Parameters
vlan vlan-id: Specifies the VLAN ID in the range of 1 to 4094. The VLAN must exist.
mac mac-address: Specifies the MAC address, which must be a valid unicast MAC address.
Usage guidelines
The EVB bridge uses a VSI filter to identify VSI traffic for a VM. Filters are usually assigned by a VSI
manager. You can also manually create or remove a VSI filter by executing this command. A VSI filter
contains a set of VID values (VLAN information) or a set of MAC and VID values (<MAC, VLAN>).
Before the configuration, make sure the S-channel where you configure a VSI filter operates in trunk mode.
Otherwise, the VSI filter configuration fails.
When a filter configured on a VSI contains information about a VLAN, you must not configure the filter
on the same VSI again or on other VSIs of the S-channel interface. Otherwise, an error message
appears.
If the VSI filter is a set of VID values, and the MAC address learning function for the corresponding
S-channel is disabled, traffic for the VSI cannot be forwarded.
Activate a VSI after configuring a VSI filter, and deactivate a VSI before removing a VSI filter.
Examples
# Configure a VSI filter for VLAN 1 on S-channel 1/0/1:10.1.
<Sysname> system-view
[Sysname] interface s-channel 1/0/1:10.1
[Sysname–S-Channel1/0/1:10.1] evb vsi filter vlan 1
Related commands
evb mac-learning forbidden
•
evb vsi active
•

interface s-channel

Use interface s-channel to enter S-channel interface view or VSI view.
18