Assembly Of The Wires (F5-K) - KEB COMBIVERT F5 Reference Manual

X2A
3.2.1 Assembly of the
wires (F5-K)
Control Connections (Safety)
D, E Housings
X4A
X2B
Terminal Description
X2A Control terminal strip
X2B STO terminal block
X3A Encoder Interface channel 1
X3B Encoder Interface channel 2
X4A HSP5 interface
The STO control card uses a spring-loaded terminal strip. Use the following
instructions when wiring the control terminals.
Required Tools:
Screwdriver SD 0.4 x 2.5 (DIN 5264)
1 Strip the line about 7mm
2 Plug screwdriver into the middle square slot
3 Plug stranded wire into the round slot; be sure no
wire is seen from the outside
4 Remove screwdriver and check if the wire is fixed.
Make sure that the stranded wire and not the
insulation is clamped.
G, H, R, U, W Housings
X4A
45