KEB COMBIVERT F5 Reference Manual page 65

BiSS / EnDat 2.2
Drive connection X3A
Screw Terminal Strip
1 2 3 4 5 6 7 8
• Max. Load capacity depending on Voltage Supply
• Max. Load capacity at +5.25V = 300 mA; 24V = 1A. The specified current is reduced by the
current taken from the second encoder interface X3B interface (see Section 3.3.9).
Biss/EnDat 2.2
Pre-manufactured BiSS/EnDat 2.2 cables offer the best solution due to high clock frequencies and
protection against noise and disturbance while saving installation time. The maximum length is
50m.
Cable Part Number
00F50C1-B0xx xx = length in meters, 10 = 10 meters
Mating Connector
0090912-004U for encoder (solder type)
Running in Conduit
When this cable must be pulled through metallic conduit, it is necessary to over size the
conduit! Use of a 1 1/2-inch trade size conduit will allow the connectors to pass without removal of
the connectors. Cutting the cable, or removal of the connectors or their housings voids the warranty
and will result in problems with electrical noise after the fact.
Circular connector on
EnDat 2.2/BiSS encoder.
BiSS / EnDat 2.2 - Encoder Connections
Pin No. Signal
1 DATA +
2 DATA -
3 CLOCK +
4 CLOCK -
5 -
6 5V
7 24V
8 COM
- GND
ONLY when the inverter is switched off and the voltage supply is discon-

nected may the feedback connectors be removed or connected!
Encoder pin-out
DATA+ 14
DATA- 17
CLOCK+
CLOCK-
+5.25V
COM 10
Shield wire tied to housing
Note: Inner pair shields are tied to 0V (com),
Description
Data Channel +
Data Channel -
Clock Channel +
Clock Channel -
5.25V voltage output for encoder supply
24V voltage output for encoder supply
Reference potential for voltage supply
Function earth is not available at the terminal block and must be
connected at appropriate place at the unit.
8
9
7
not earth ground!
X3A pin-out channel 1
1 DATA+
2 DATA-
3 CLOCK+
4 CLOCK-
6 +5.25V
8 COM
Shield wire tied to housing
which is earth ground.
Wire color
Pink
Blue
Green
Yellow
Red
Black
65