Model Numbers And Nameplate Checks; Model Numbers And Nameplate Checks; Drive Nameplate - YASKAWA P1000 Technical Manual

1.3 Model Numbers and Nameplate Checks

1.3

Model Numbers and Nameplate Checks

Please perform the following tasks after receiving the P1000 Bypass
• Inspect the P1000 Bypass for damage.
If the P1000 Bypass appears damaged upon receipt, contact the shipper immediately.
• Verify receipt of the correct model by checking the information on the nameplate.
• If you have received the wrong model or the P1000 Bypass does not function properly, contact your supplier.
If you find any irregularities in the above items, contact the shipping company, the distributor or representative you purchased
the P1000 Bypass from or your Yaskawa office immediately. The P1000 Bypass is thoroughly tested at the factory. Any
damages or shortages evident when the equipment is received must be reported immediately to the commercial carrier that
transported the material. Shipping damage is not covered by the Yaskawa warranty. After unpacking and inspecting for damage,
verify that internal wire connections have not come loose during shipment by spot checking wire terminations with a
screwdriver or the appropriate tool. P1000 Bypass storage must be in a clean and dry location. Maintain the factory packaging
and provide covering as needed to protect the P1000 Bypass from construction site dirt, water, debris and traffic prior to and
during construction.
u

Drive Nameplate

A – Normal Duty Amps
B – Software version
C – Enclosure type
D – Serial number
28
H CIMR-PU2A0004FAA
MODEL :
: CIMR-PU2A0004FAA
C/C
G
INPUT : AC3PH 200-240V 50/60Hz 3. 9A
F OUTPUT : AC3PH 0-240V 0-400Hz 3. 5A
MASS : 3. 3 kg
E O / N : 6W3050-0-100
D
S / N : J0073D207410100
FILE NO : E131457 IP20
YASKAWA ELECTRIC CORPORATION
C
Figure 1.1 Drive Nameplate Information Example
YASKAWA SIEP YAIP1B 01B YASKAWA AC Drive – P1000 Bypass Technical Manual
A
REV : A
IND.CONT.EQ.
7J48 B
B
PRG : 8500
VAJ123456
PASS
Assembled in USA
E – Lot number
F – Output specifications
G – Input specifications
H – AC drive model