Valet Take-Over - Clifford Model RSX3.5 Owner's Manual

When you are ready to drive the vehicle:
note: If the brake pedal is pressed before the key is in the
ON position, the engine will shut down.
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut
down the engine if the system receives any of the following shut-
down inputs:
➤ The brake pedal is pressed.
➤
The hood is opened.
➤
The shutdown toggle switch is put into the OFF position.
➤ The pre-programmed run time (12, 24, or 60 minutes) has
elapsed.
➤
Transmitter button
➜

valet take-over

The Valet Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
28
1. Insert the ignition key and turn
it to the ON (not the START)
position.
2. Press the brake pedal.
is pressed again to start the vehicle.
© 2005 directed electronics—all rights reser ved