Valet Take-Over; Short-Run/Turbo - Clifford Model RSX1.2 Owner's Manual

Clifford model rsx1.2 owner's guide

Hide thumbs Also See for Model RSX1.2:

Table of Contents

note: If the remote start is on the lights will turn off then

flash 3-times before returning to their normal output and

the defogger output will activate as programmed.

➜

valet take-over

The Valet Take-Over feature allows the vehicle to remain running

after the key has been removed from the ignition. This feature is

useful for occasions when you wish to exit and lock the vehicle

for short periods of time, but would like to leave the motor

running and the climate controls on.

To perform Valet Take-Over:

1. Before turning off the engine, press and release

way remote twice within 3 seconds. Then wait five seconds.

2. Turn the ignition key to the OFF position. (The engine will

stay running.)

3. The engine will run until the pre-programmed time elapses

or a shut-down input is received. (See the previous Remote

Start section for a complete list of shut-down inputs.)

note: This feature will not work if the brake pedal is

pressed.

4. The remote start responds with remote start tones and the

Yellow LED illuminates for 3-seconds.

➜

Short run turbo mode keeps the engine running after arriving at

on the 2-

Table of Contents