Plainview 2 Coded Valet Switch; Driver's Door Trigger; Brake Lights - Clifford BlackJax 5 Installation Manual

Hide thumbs Also See for BlackJax 5:
Table of Contents

Advertisement

plainview 2 coded valet switch

The PlainView 2 switch does not need to be hidden. Rather, it should be mounted on
the dashboard or console within easy and convenient reach of the driver. Discuss
placement of the switch with the vehicle owner prior to installation.
N N O O T T E E : : Be sure to check for clearance behind the dashboard or console prior to drilling.
1.
Drill a 9/32-inch hole to mount the switch.
2.
Route the wires and connectors through the hole and secure the switch.
3.
Mate the switch connector to the small connector on the wireloom, noting the
wire colors.

driver's door trigger

This connection is necessary to initiate the BlackJax countdown. The factory default
setting is negative door trigger. If positive door trigger is required (on Rolls-Royce and
some Ford vehicles), then refer to the features programming section of this manual.
1.
Locate the wire coming off the rear of the vehicle's door switch.
2.
Connect the negative voltmeter lead to ground.
3.
Find the one wire that shows (+)12V when the switch is pressed in and 0V when
released. This is a negative door trigger wire. If you do not find this wire
continue to the next step, else proceed to step 5.
4.
Find the one wire that shows 0V when the switch is pressed in and 12V when
released. This is a positive door trigger wire. The Features Programming will
have to be set for positive door trigger (discussed later in this manual).
5.
Connect the control unit's GRAY wire to this door trigger wire.
N N O O T T E E : : DirectTechs web site (www.directechs.com) for authorized Directed dealers
has detailed descriptions of wire colors and locations for most foreign and domestic
vehicles.

brake lights

For safety reasons, BlackJax is wired to the brake light rather than the parking lights.
Also, pressing the brake after the door has been opened/closed starts the BlackJax
countdown. When BlackJax is activated, the flashing brake lights will warn motorists
that are driving behind the carjacked vehicle.
© 2005 directed electronics—all rights reserved
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents