Exmark UltraVac 126-8680 Setup Instructions page 5

1. Blower
2. Belt cover
3. Push down on the back of the cover and slide it
backwards under the blower.
4. With the belt cover resting on the deck, slide it
forward until it is seated under both lips on the deck.
1. Blower
2. Belt cover
5. Install the knob and its hardware.
Installing the Hopper Assembly
1. Lay the hopper assembly down behind the machine.
Pick up the bagger frame legs and hook the notch
onto the lower bagger mount bar as shown in
Figure 10.
Figure 8
3. Mower frame
Figure 9
3. Deck lip
g242180
1. Lower bagger mount bar
2. Lift the hopper assembly and pivot it upward towards
the back of the machine. Attach the rod support to
each side of the rear frame as shown in Figure 11.
g009341
1. Rod support assembly
2. Bagger pin
3. Washer
3. Raise the hood and install the bag assemblies by
sliding the bag frame hooks onto the retaining slots
on the hopper frame.
4. Close and latch the hood.
5
Figure 10
2. Frame leg
Figure 11
Right side shown
4. Mount pin with lanyard
5. 1/2 inch lock nut
g242492
g242046