6.2.1.2 Axial fastening
Depending on type, secure the hollow shaft axially on the machine shaft (e.g. with locking ring, end plate,
set screw, slotted nut).
Fig. 13: Axial fastening
6.2.2
Demounting
•
Remove the axial securing device from the hollow shaft.
•
Depending on the facilities available on site, the gear unit may be forced off the shaft using forcingoff
bolts in an end plate (see figure 14), a central threaded spindle or preferably a hydraulic lifting unit.
2
3
1
Fig. 14: Demounting
1
Machine shaft
2
Hollow shaft
3
Parallel key
Instead of the nut and threaded spindle, preferably use a hydraulic lifting unit for this.
Avoid canting when pulling the unit off.
4
Hydraulic lifting unit
5
Threaded spindle
6
Auxiliary plate for forcing out
BA 5814 en 09/2014
29 / 61
Set screw
Steam head
6
4
5