Table of Contents
Advertisement
10.
Maintenance and repair
Observe the instructions in section 3, "Safety instructions" and in section 9, "Faults, causes and remedy"!
10.1
General notes on maintenance
All maintenance and repair work must be done with care and by duly trained and qualified personnel only.
The following applies to all work in item 10.2:
Switch the gear unit and addon components off.
Secure the drive unit to prevent it from being started up unintentionally.
Attach a warning notice to the start switch!
The periods indicated in table 11 largely depend on the conditions under which the
gear unit is operated. Only average periods can therefore be stated here. These refer
to:
Under different operating conditions the periods indicated below must be adjusted
accordingly.
Table 11: Maintenance and repair work
Measures
Check the oil temperature
Check for unusual gear-unit noise
Check the oil level
Check the gear unit for leaks
Test the water content of the oil
Perform the first oil change
Perform subsequent oil changes
Clean the air filter
Clean the gear unit
Check the hose lines
Change the hose lines
Check tightness of screw
connections
Check the auxiliary drive unit
Check the shrink disk
Inspection of the gear unit
a daily operating time of
a duty factor of "ED"
an inputdrive speed of
maximum oil temperature of
Daily
Daily
Monthly
Monthly
After approx. 400 operating hours
once per year at least
Approx. 400 operating hours
after start-up
Every 24 months or
10 000 operating hours
Every 3 months
Every 5000 operating hours
Yearly
6 years from the manufacturing date
impressed
After the first oil change,
then every 2 years
Every 3 months
Every 12 months
Approx. 2 years
BA 5814 en 09/2014
24
h
100
%
1500
1/min
90
°C (applies to mineral oil)
Periods
54 / 61
Remarks
See item 10.2.1.
See item 10.2.2.
See item 10.2.2.
See item 10.2.3.
See item 10.2.4.
See item 10.2.5.
See item 10.2.5.
See item 10.2.6.
See item 5.11.
See item 6.3.2.5.
See item 10.4.
Advertisement
Table of Contents
