Operation Operating Principles; Status Display With Lightguide; Screen Displays; Standby - Viessmann VITODENS 200-W Operating Instructions For The System User

Operating principles
Display
You can adjust any setting on your system centrally at
the control unit.
The control unit is equipped with a black/white screen.
To input settings and check information, tap the on-
screen buttons.
Remote control for weather-compensated opera-
tion
If remote control units are installed in your rooms, you
can also adjust the settings at the remote control units.
Remote control operating instructions

Status display with Lightguide

Depending on the type of heat generator, a red illumi-
nated strip (Lightguide) is displayed at the lower or
upper edge of the control unit during operation.
Meaning of the display:
■ Lightguide pulsates slowly:
Display is in standby mode.
Lightguide is illuminated constantly:
■
You are operating the control unit. Every input opera-
tion is confirmed by a brief flashing.
■ Lightguide flashes quickly:
There is a fault on the system.

Screen displays

Standby

The display backlighting is switched off after approx.
2 minutes.

Home screen

After switching on or activating the control unit the
home screen is shown.
The home screen shows information about the system
status.
Call up the home screen as follows:
Standby is active:
■
Tap any button.
■ From anywhere in the menu:
Tap repeatedly until the home screen is shown.
Room temperature controller for room tempera-
ture-dependent operation
If a room temperature controller is installed in one of
your rooms, you can adjust some settings at the room
temperature controller.
Operating instructions, room temperature con-
troller
Individual room control
If ViCare components are installed in your room, you
can make the settings via the app or via the compo-
nents.
Note
You can switch off the Lightguide. See page 34.
Note
If your contractor has set up your heat generator to
provide only DHW heating or to operate in weather-
compensated mode with a room temperature control-
ler, the information for "DHW" will be shown.
Operation
15