Schwinn 190 Service Manual page 98

Section 2
1. Using a 6 mm hex wrench, remove the indicated
hardware from the Console Mast. Slightly pull the Console
Mast upward, and disconnect the cables. Leave the plastic
insert and Frame cable connector in place. Set the hardware
and Console Mast assembly safely aside for reassembly.
NOTICE: Do not pinch or cut the cables.
This step may require two people.
2. Flex the edges of the Top Shroud to disengage the inside
tabs from the Main Assembly. Remove and set it safely
aside.
Note: It may be easier to pry up the edges of the Top
damage to the surface of the Shrouds, we
recommend putting a piece of cloth over the
screwdriver blade.
6mm
Cable
connector
98
X4