Schwinn 190 Service Manual page 65

17. Press the clips on the new Console Cable connector and
align the tab on the connector with the notch in the smaller
hole in the new plastic insert. Push the connector through
the hole. Be sure the clips lcck the connector in position.
NOTICE: Do not pinch or cut the cable.
18. Press the plastic insert into position in the Console Mast
mount.
NOTICE: Do not pinch or cut the cable.
19. Carefully connect the Console Cable (C1) to the PCBA.
NOTICE: Do not pinch or cut the cables. Be sure the
cable connections for the PCBA are correct.
Replace ziptie on the cables and secure the
cables in the cable clips to prevent interference
from moving parts.
If you are replacing the Sensors/Servo Cable (wiring harness),
continue to step 20.
If you are replacing the Power Cable, go to step 26.
Otherwise, go to step 31.
To replace the Sensors/Servo Cable assembly:
20. Observe the routing of the individual cables in the Sen-
sors/Servo Cable assembly (wiring harness) to the Resis-
tance Sensor, the RPM Sensor cable and the Servo Motor.
Left side (
RPM sensor
W1
R1 R1
Servo Servo
motor motor
W1
R1 R1
resistance resistance
Clip Clip
Connector Connector
Clip Clip
cable cable
65
Insert Insert
Tab Tab
Notch
Resistance Resistance
resistance resistance
sensor sensor
W1 W1