Automatic Malfunction Bypass; Totalrecall; Smart Prior Intrusion Attempt Alert; Fact - False Alarm Control And Test - Clifford 500 Owner's Manual

Automatic malfunction bypass

To provide protection even if a component malfunctions, the system automatically
bypasses any faulty point and arms all other triggers and sensors to provide the
utmost possible protection until you can have the system serviced by your local
Authorized Clifford Dealer.

TotalRecall™

The system's memory records the identity of the last activated or malfunctioning
trigger or sensor, which allows your installer to instantly track down a malfunction.
To identify the trigger or sensor held in the memory, use the following procedure:
1. With the ignition OFF, flick the valet switch.
2. Press button 1 to "arm" the system, then again to "disarm."
3. The LED will blink 1–3 times to indicate the most recently activated trigger or
sensor. For your convenience, the blink cycle will pause and repeat a total of 5
times. Refer to the chart below:
Number of LED blinks between pauses
1 blink
2 blinks
3 blinks

Smart prior intrusion attempt alert

If you hear three chirps when you remotely disarm, it means that a trigger or sensor
was activated in your absence. When you enter the vehicle and turn on the ignition
(or start the engine), the LED will blink 1–3 times, pause, then repeat the blink cycle
4 more times. Count the number of blinks in one cycle and refer to the chart above.
FACT™— False Alarm Control and Test
With FACT, you'll never experience repeated false alarms. If the siren goes off, DO
NOT remotely disarm the system; allow it to run for the full siren duration. Before
sounding the siren a second time, the system automatically checks for another
activated trigger to verify that an intrusion is in progress. Should the siren sound
again, you will know for sure that someone is tampering with your vehicle. (To
disable FACT, see User-selectable features on pages 15-16.)

Smart trunk release option

If the remote trunk release feature was installed, you may use remote control button
2 to remotely pop the trunk. Your system has a built-in electronic interlock to
prevent unintentional activation of the remote trunk release when you drive, or
when the system is armed.
Trigger/sensor indication
Proximity Sensor or Piezo Sensor
Door trigger
Hood or trunk trigger
13