Smart Autotesting™ With Verbal Diagnostics; Specific Malfunction Identification; Automatic Malfunction Bypass; Verbal Eight-Event Totalrecall - Clifford intellivoice IQ Vechicle Security Owner's Manual

Smart AutoTesting™ with Verbal Diagnostics
Each time you remotely arm the system, it tests all triggers and sensors. If the hood or
trunk is open when you remotely arm, the system will immediately alert you of the
problem after saying "ARMED" by sounding a door-bell-like chime and flashing the
parking lights 4 times instead of the usual 2 times. If a door is ajar, you'll hear
"ARMED," then, 5 seconds later, there will be the chime and 4 flashes. (The door ajar
warning will not work on vehicles with delayed courtesy lights). If a sensor is
malfunctioning, you'll hear "ARMED," then, 10 seconds later, there will be the chime
and 4 flashes.

Specific malfunction identification:

trigger or sensor that is malfunctioning. If you receive the chime signal upon remote
arming, perform the following to identify the malfunctioning trigger or sensor:
1. Remotely disarm, then turn on the ignition. The system's passenger compartment
speaker will verbally tell you which sensor or trigger point is open or active.

Automatic malfunction bypass

To provide the utmost protection even if a system component malfunctions, the system
will automatically bypass any faulty point and arm all other triggers and sensors to
provide the utmost possible protection until you can have the system serviced by your
local Authorized Clifford Dealer. If you accidentally armed with the hood, trunk or a
door open, just close the open point and the system will again monitor that point.

Verbal eight-event TotalRecall™

The system's memory records the identity of the last eight activated or malfunctioning
triggers and sensors, which allows your installer to instantly track down malfunctions. Your
IntelliVoice-IQ, however, will verbally tell you what was the most recently activated trigger
or sensor. Just use the following procedure:
1. With the ignition OFF, flick the PlainView valet switch to its latched side.
2. Press button 1 to "arm" the system, then again to "disarm."
3. The IntelliVoice-IQ passenger compartment speaker will verbally announce the most
recently activated trigger or sensor.

Smart prior intrusion attempt alert with voice warning

If you hear a door-bell-like chime when you remotely disarm, it means that a trigger or
sensor was activated in your absence. When you enter the vehicle and turn on the
ignition (or start the engine), the system's passenger compartment speaker will verbally
announce which trigger or sensor detected the attempt.

Smart trunk release option

If the remote trunk release feature was installed, you may use the remote control's
button 2 to remotely pop the trunk. Your IntelliVoice-IQ has a built-in electronic
interlock to prevent unintentional activation of the remote trunk release when you drive,
or when the system is armed.
The system can even indicate the specific
14