Advertisement
INSTALLATION OF FEET (REAR)
Holding the product securely loop the U bolt around the spacer between the last 2 fins (see fig. 4).
Attach the rear castor bar (the rear castor bar has 2 holes) to the U bolt making sure that the locator
pin aligns with the locator hole (see fig. 5) and the 2 threaded bolts pass through the 2 screw holes,
securing tightly with 2 wing nuts (see fig. 6). Make sure the feet are secure before turning over.
Fig. 4
Fig. 5
Fig. 6
OPERATION
Plug the mains lead into a 13Amp socket and switch the product on at the mains. Using the two power
switches on the side of the product select the required operation.
1. Make sure the selector switch is switched to position I see (Timer section below) for manual operation
2. Both switches off = Off
3. Left switch on right switch off = Low heat (1kW)
4. Left switch off right switch on = Medium heat (1.5kW)
5. Both switches on= High Heat (2.5kW)
This product is also fitted with an adjustable thermostat. After selecting the required heat setting turn
the thermostat clockwise until it reaches its furthest point. Allow the room to heat up to the required
temperature and then rotate the thermostat anti-clockwise until you hear the radiator click off. Leaving
the thermostat in this position will maintain the temperature at this level.
The unit can work as a frost protection radiator, to do so turn the thermostat fully anti-clockwise to the
minimum setting. In this position the radiator will only switch on at low temperatures.
Please note that in very large room or draughty rooms the product might be insufficient to reach the
required temperature.
RADIATOR MODE BUTTON
0 = Off (this will switch the radiator off even when not being used with
the timer.
Clock= Timer Mode
I = On manual
TIMER INSTRUCTIONS
1) Set the mode button to timer
2) Set the time by rotating the outer dial until the current time is in line
with the pointer arrow
3).The timer is controlled by moving the plastic segments in and out
from the centre. Each segment is equal to 15 minutes. Moving the
segment out (away from the centre) will switch the unit on and towards
the centre will turn the product off
3
Advertisement
