Download Print this page

General Safety Requirements; Maintenance - Prem-I-Air EH1846 User Manual

2.5kw 11 fin oil filled radiator

Advertisement

When used in a workplace, this product should be safety-tested yearly by a qualified electrician (PAT
Tested). We recommend that it is PAT tested regularly when used in a domestic environment.
Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at
every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must be inspected at least
once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory for new buildings).
At time of going to press, the average cost of electricity is £0.145 per unit (kilowatt-hour). The amount
you are being charged will be shown on your electricity bill.
At this cost, the EH1846 will cost £0.36 per hour to run with the thermostat set to its maximum.
If the thermostat is used to regulate the temperature the operating costs will be lower, depending on
the room temperature.
Before cleaning, turn the radiator off, and disconnect from the mains supply. The radiator may then be
cleaned using a damp cloth with a drop of washing-up liquid to remove any dust or dirt from the case.
Do no use stronger detergents or solvents as these may damage the plastic.
Using a dry 1" (25 mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or an authorised service centre.
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and disposal is free of charge to the
end-user.
When replacing an existing appliance with a similar new appliance your retailer may take the old
appliance for disposal.
Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of two
years.
Should this unit be operated under conditions other than those recommended, at voltages other than
the voltage indicated on the unit, or any attempts made to service or modify the unit, then the warranty
will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This warranty is in addition to, and
does not affect, your statutory rights.
If you have any problems with this product, please call our Help Desk on (0845) 459 4816.
PAT TESTING

GENERAL SAFETY REQUIREMENTS

OPERATING COSTS

MAINTENANCE

If the mains plug needs to be replaced, proceed as follows:
• Connect the brown wire to the terminal labelled "L".
• Connect the blue wire to the terminal labelled "N".
• Make sure that the cord-grip is positioned correctly (over the outer
sheath of the cable) and it fully tightened.
DISPOSAL AND RECYCLING
SERVICE WARRANTY
4

Advertisement

loading