Pat Testing; General Safety Requirements; Operation - Prem-I-Air EH1434 Manual

PAT TESTING

When used in an office environment, this product must be
safety-tested yearly by a qualified electrician (PAT Tested) in
order to comply with the Electricity at Work Regulations.
It is good practice that appliances are regularly PAT tested
when used in a domestic environment.

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified
electrician at least once every 10 years or at every change
of occupancy. For office and retail premises, and buildings
such as village halls, the wiring must be inspected at least
once every 5 years.
It is recommended that all building be fitted with smoke
alarms (it is mandatory for new buildings).

OPERATION

Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 10 Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket.
Use the two switches on the side to select the required
operation:
• 750 W switch on = Low Heat (750 W)
• 1250W switch on = Medium heat (1250 W)
• Both switches on = High Heat (2000 W)
Do not touch the air output grille when the heater is in
operation, because it will be hot and may cause burns.
Unplug the heater from the mains when not in use.
Page 5