Received Data Dump - Kyocera FS-C8100DN Advanced Operation Manual

6 To set the sleep timer, press [OK]. A blinking question mark (?)
appears.
7
Press
8 Press [OK]. The sleep timer is turned off.
9 To exit the menu selection, press [Menu].
Sleep Timer Timeout Time
You can adjust the length of time the printer waits before entering Auto Sleep in the absence of
data. The default time is 15 minutes.
The printer reverts to normal operation mode when the printer receives a print job, the operation
panel is operated, or one of the exterior covers is opened.
1 Press [Menu].
2 Press
3 Press
4 Press
5 To change the timeout time, press [OK]. A blinking cursor (_)
appears.
6 Press
timer can be set between 5 and 240 min, in 5-minute increments. Use
right and left.
7 When the desired timeout time is displayed, press [OK].
8 To exit the menu selection, press [Menu].

Received Data Dump

You can print data received by the printer as hexadecimal code for debugging programs and files.
Press [Menu].
1
2 Press
or to change On to Off.
or repeatedly until Others > appears.
.
or repeatedly until >Sleep Timer > appears.
or to increase or decrease the value at the blinking cursor and set the desired time. The
or repeatedly until Others > appears.
Using the Operation Panel
>>Auto Sleep
? On
>>Auto Sleep
? Off
Others
>Sleep Timer
015min.
>Sleep Timer
015min.
and to move the cursor
Others
>
>
>
2-67