Selecting The Output Stack - Kyocera FS-C8100DN Advanced Operation Manual

1 Press [Menu].
2 Press
3 Press
4 Press
5 To activate duplex printing, press [OK]. A blinking question mark
(?) appears.
6 Press
following:
7 When the desired binding mode is displayed, press [OK]. The binding mode is set.
To exit the menu selection, press [Menu].
8

Selecting the Output Stack

The Stack Select menu on the operation panel allows you to select either the face-down tray or the
faceup tray option for the output stack.
1 Press [Menu].
2 Press
3 Press
4 Press
5
To change the output stack, press [OK]. A blinking question mark
(?) appears.
or repeatedly until Paper Handling > appears.
.
or repeatedly until >Duplex Mode appears.
or to display the desired binding mode. The message display toggles through the
Off (default)
Short edge bind
Long edge bind
or repeatedly until Paper Handling > appears.
.
or repeatedly until >Stack Select appears.
Using the Operation Panel
Paper Handling >
>Duplex Mode
Off
>Duplex Mode
?Off
Paper Handling >
>Stack Select
Top tray FaceDn
>Stack Select
?Top tray FaceDn
2-57