Step 8 Turning The Power Switch On; Selecting Message Language - Kyocera Ecosys FS-3820N Installation Manual

STEP
8
Turning the Power Switch On
This section describes the procedure for turning on the printer's power.
During start-up, the language for the message display and status page of this printer
can be selected from English, French, German, Italian, Dutch, Spanish, and Portu-
guese.
The default message language is English. For how to change the message lan-
guage to another, refer to the Selecting a Message Language section.
Power Switch
Ready
--- A4 PLAIN
Selecting a Message Language
The default message language is English. To change the message language to
another, follow the procedure described below. If required, your dealer can down-
load major languages other than English, French, German, Italian, Dutch, Span-
ish, and Portuguese to your printer. Please contact your dealer.
GO
CANCEL MENU
Please wait
18
1
Switch on the printer's power. The mes-
sage display should indicate Self
test.
When the printer is first switched
on after installation, there will be a
delay of approximately 8 minutes
before the printer gets ready to
print as the developer unit needs to
be filled with toner. During this
period, the message display shows
Please wait (Adding toner).
2
Wait until the READY (
also lit and the message display indi-
cates Ready. The printer is ready to
print.
1
While pressing the ENTER key, turn the
power switch ON ( l ). Keep pressing the
ENTER key until the message display
?
indicates Please wait (approximately
1 minute). The message display should
ENTER
indicate Self test.
2
When the message display shows
Please wait, release the ENTER key.
If the indicator does not light,
check that previous steps were
performed properly.
) indicator is